October 23, 2026
How to remove ums and uhs from a video on Mac
Everyone says “um”. On camera it just sounds louder. The good news: removing them is mostly a matter of finding them, and there are faster and slower ways to do that.
Option 1: by hand, in any video editor
This works in iMovie, Final Cut Pro, Premiere Pro, DaVinci Resolve, anything with a timeline.
- Turn on the audio waveform and zoom into the timeline so a second of video is wide on screen. Fillers are short, often a third of a second.
- Play and listen. When you hear an um, stop, and step back to where it starts.
- Split the clip at the start and at the end of the um (in most editors: move the playhead, then the split or blade shortcut).
- Delete the piece and close the gap. Most editors have a “ripple delete” that pulls everything after it to the left.
- Listen across the cut. If you hear a click or half a breath, move the cut a few frames.
It’s free and precise, and it’s slow: you listen to the whole video at least once, and each um is four or five actions. When I edited one of my own 12-minute videos this way, it had 37 fillers.
Tip: cut in the quiet around the filler, not exactly at its edges. A cut a little before the “um” starts and a little after it ends sounds smoother than one that’s tight on both sides.
Option 2: read a transcript first
If your editor (or a separate app) can make a transcript with timestamps, you can read instead of listen: search the text for “um”, “uh”, “erm”, and jump to each one. You still make the cuts by hand, but finding them goes much faster.
One catch: many transcription tools leave the ums out on purpose, to make the text read nicely. If yours does, the search finds nothing even when your video is full of them. Check a few seconds you know have an um before relying on it.
Option 3: let the editor find them
This is what I built Transcut Studio for. It transcribes your video on your Mac, writes every um down, and marks it in the text, together with stutters (“I, I went”) and words you started twice (“th- the”).
- Drop in your video and wait for the transcript (words appear within seconds).
- Open Review: every filler is in one list.
- Listen to any of them, before and after the change.
- Press Accept all to remove every sure one in one go, or accept them one at a time.
Words that are only sometimes fillers, like “like”, “so” or “you know”, are marked Maybe and never removed in bulk: you listen and decide each one. One undo brings everything back. More detail on the filler words page.
Don’t remove all of them
A video with every single um removed can sound breathless, like someone who never thinks. Keep the ones that sit in a natural pause, and remove the ones that interrupt a sentence. Listening before you accept helps with exactly this.
Say fewer of them next time
- Pause instead. An um is usually your brain buying time. A silent pause does the same job, and silence is easy to shorten later (see removing silences).
- Know your first sentence before you hit record. Most fillers cluster at the start of a thought.
- Keep the camera rolling and say it again when you trip up. A clean second take is easier to keep than a sentence full of ums; Transcut finds those retakes too.